Step 1
Apply a thick layer of good quality PVA glue to the ends of the Flower Soft wires.

Step 2
Put Flower SoftTM into a larger dish and run through fingers to separate. Whilst glue is still wet dip the wire into the Flower SoftTM and shake off the excess.

Step 3
Cut approximately 5cm square of tissue paper and fold corner to corner to make a triangle. Roll into a cone as above. Glue down end at the back.

Step 4
Trim the ends of the florists wire to make level and apply PVA glue, push into tissue paper cone and leave to dry.

Step 5
Draw a straight line in light pencil where ribbon is required - follow with PVA and add ribbon (pulling taut). Add bow to hide join.

Step 6
Stick bouquet into position and send to someone special...